2006 Ford Focus

Nearside Front Lower Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Rear fog lamp does not emit a steady red light (4.5.4 (a))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Brake pipe corroded, covered in grease or other material front to rear pipes starting to corrode (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Brake pipe corroded, covered in grease or other material front to rear pipes starting to corrode (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front rear brake pipes starting to corrode

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front rear brake pipes starting to corrode

Offside Front Lower ball joint slight play

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

parking brake. Requirements only just met. It would appear that the braking system requires adjustment or repair

Front Headlamp aim not tested (1.8.A.1c) DANGEROUS

Headlamp not working on dipped beam (1.7.5a)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)