2008 Land Rover Range Rover Sport

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake pad(s) wearing thin Both sides (1.1.13 (a) (ii))

air suspension fault

Nearside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

air suspension fault

under trays fitted not allowing full inspection

Windscreen washer provides insufficient washer liquid (8.2.3)

under trays fitted not allowing full inspection

Centre stop lamp faulty unit and not connected

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Centre Stop lamp not working (1.2.1b)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar synthetic mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

suspension fluid reservoir below min level

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Side repeater excessively damaged so that it is not visible from a reasonable distance (1.4.A.2e)

Nearside Side repeater not working (1.4.A.2c)

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tie bar/rod has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Under-trays fitted obscuring some underside components

Parking brake: efficiency below requirements (3.7.C.1b)

Engine covers fitted obscuring some components in the engine bay

Nearside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Under-trays fitted obscuring some underside components

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)