2013 Peugeot 208

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Sub-frame corroded but not seriously weakened rear axle (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear axle corroded

Central Exhaust system insecure (6.1.2 (a))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Side repeater likely to become detached (4.4.1 (c) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear axle corroded

Front Exhaust mounting defective (6.1.2 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases near to flexi pipe (6.1.2 (a))

Exhaust has a minor leak of exhaust gases near to rear exhaust bracket (6.1.2 (a))

rear exhaust bracket corroded

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases near to flexi pipe (6.1.2 (a))

Exhaust has a minor leak of exhaust gases near to rear exhaust bracket (6.1.2 (a))

rear exhaust bracket corroded

Passenger's seat backrest cannot be secured in the upright position. (6.2.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust system not adequately supported (7.1.1)