2002 Subaru Forester

Windscreen washer provides insufficient washer liquid (3.5 (a))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen washer not working (3.5 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

both rear trailing arm bushes perished

front drop link bushes perished

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

both rear trailing arm bushes perished

exhaust in pour condition

front drop link bushes perished

Front exhaust flange to mid section rotten

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Sub-frame corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Front exhaust flange to mid section rotten

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre sidewall cracked.

Central Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Inner Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre sidewall cracked.

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

slight exhaust blow.

slight noise on n/s/r wheel bearing

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

slight exhaust blow.

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Registration plate lamp not working (1.1.5c)