2006 Iveco Daily

Nearside Front WINDSCREEN DAMAGE

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake cable damaged (1.1.15 (a))

Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Fuel tank insecure (6.1.3 (a) (i))

Nearside Front Body component damaged and likely to cause injury INDICATOR LENS SHARP EDGES (6.2.1 (a) (i))

Nearside Front Brake hose excessively twisted FOULING ON SHOCK ABSORBER (1.1.12 (b) (ii))

Nearside Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength REAR SPRING MOUNT BRACKET (5.3.6 (a) (i))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced CROSS BEAM PROP SHAFT MOUNTED ON (6.1.1 (c) (i))

Offside Front Brake hose excessively twisted FOULING ON SHOCK ABSORBER (1.1.12 (b) (ii))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake hose ferrule excessively corroded CHASSIS TO REAR AXLE HOSE (1.1.12 (f) (i))

Rear Brake pipe likely to become detached or damaged BRACKET CORRODED AT CHASSIS FOR FLEXI HOSE TO AXLE (1.1.11 (d) (ii))

Rear Electrical wiring insulation so damaged or deteriorated it is likely to cause a short-circuit (4.11 (c) (ii))

Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength REAR CROSSBEAM AT NEARSIDE (5.3.6 (a) (i))

Offside Rear Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

ALL CAB RUBBER MOUNTS WORN

Anti-roll bar pin or bush worn but not resulting in excessive movement ALL REAR BUSHES (5.3.4 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

CORROSION AT OFFSIDE FRONT CAB MOUNTING

Leaf spring has slight wear in an anchor pin and/or bush ALL LEAF SPRING BUSHES (5.3.4 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge OUTER EDGE CLOSE TO HAVING PLY OR CORDS EXPOSED (5.2.3 (e))

Offside Rear Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake pipe slightly damaged (1.1.11 (c))

SIGNS PROPSHAFT FOULING WITH VEHICLE UNDER LOAD

Central Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Battery insecure (1.9.1)

Bonnet cannot be secured in the closed position (8.4.1)

Front Fuel system component leaking (7.2.3)

Front Upper Front position lamp(s) not working BOTH (1.1.A.3b)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Upper Ball joint has excessive play (2.2.B.1f)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Side repeater incorrect colour (1.4.A.2f)

Offside Front Upper Ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

Central Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Brake load sensing valve defective and function impaired (3.6.E.3)

Indicator switch faulty (1.4.A.1)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front Direction indicator damaged, but still visible from a reasonable distance (1.4.A.2e)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Front Side repeater slightly discoloured (1.4.A.2f)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Brake load sensing valve linkage obviously incorrectly adjusted (3.6.E.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Direction indicator damaged, but still visible from a reasonable distance (1.4.A.2e)

Offside Front Direction indicator damaged, but still visible from a reasonable distance (1.4.A.2e)

Offside Front Direction indicator damaged, but still visible from a reasonable distance (1.4.A.2e)

Offside Inner Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Inner Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Outer Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Direction indicator damaged, but still visible from a reasonable distance (1.4.A.2e)

Offside Outer Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Side repeater not working (1.4.A.2c)

Nearside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Road wheel slightly damaged (4.2.A.1a)

o/s/f side marker

Nearside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Leaf spring has a deteriorated shackle pin rubber bush resulting in excessive movement (2.4.B.2)

Side repeater incorrect colour (1.4.A.2f)