2007 Ldv Maxus

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Central Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Seat belt installation anchorage insecure (10.1 (d))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength within subframe mounting area (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively damaged significantly reducing structural strength within subframe mounting area (5.3.6 (a) (i))

Offside Rear Brake pipe excessively corroded to flexy as marked (1.1.11 (c))

Service brake efficiency below requirements (1.2.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material Behind Road Wheel (1.1.11 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake pipe corroded, covered in grease or other material Behind Road Wheel (1.1.11 (c))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords Inner Wall (5.2.3 (d) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Brake pipe corroded, covered in grease or other material Behind road wheel, corroding (1.1.11 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake pipe corroded, covered in grease or other material Behind road wheel, corroding. (1.1.11 (c))

Offside Rear reflector defective or damaged by up to 50% of the reflecting surface (4.8.1 (a) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material to load valve (1.1.11 (c))

Power steering inoperative (2.1.5 (c) (i))

Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength n/s and o/s inner arch (5.3.6 (a) (i))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material to load valve (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner step (7.1.1 (a) (i))

Offside Rear Service brake lagging in operation (1.2.1 (d))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

offside inner sill corroded not within prescribed area

Battery insecure (1.9.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside Rear Outer Suspension spring mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Rear fog lamp emits a light other than red (1.3.2e)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Rear fog lamp emits a light other than red (1.3.2e)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Items removed from driver's view prior to test

new brake parts fitted may need to "beddin"

Battery insecure (1.9.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Items removed from driver's view prior to test

advanced wear to inside of each front brake disc

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Front position lamp(s) incorrect colour (1.1.A.3e)

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Vehicle's internal headlight adjuster altered to recheck lights

advanced wear to inside of each front brake disc

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Windscreen wiper blade insecure (8.2.2)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS

both front brake discs slightly worn

slight play in n/s/r wheel bearing

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Headlamp not working on dipped beam (1.7.5a)