2007 Iveco Daily 35C15 Mwb

Brake hose has slight corrosion to ferrule all (1.1.12 (f) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Rear Parking brake inoperative on one side caliper arm seized (1.4.1 (a))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced inner sill (7.1.1 (a) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake hose has slight corrosion to ferrule all (1.1.12 (f) (i))

Nearside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Lower Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all (6.1.1 (c) (i))

Nearside Body fixing missing, but overall security not significantly reduced (6.2.2 (c) (i))

Offside Body fixing missing, but overall security not significantly reduced (6.2.2 (c) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Body fixing missing, but overall security not significantly reduced (6.2.2 (c) (i))

Offside Body fixing missing, but overall security not significantly reduced (6.2.2 (c) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Floor excessively deteriorated Above the cab and n.s and o.s of floor in back of van. (6.2.4 (a) (i))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Exhaust system insecure Exhaust rubber split on longer securing. (6.1.2 (a))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Inner Vehicle structure has excessive corrosion which adversely affects braking or steering Under bonnet under washer bottle. (6.1.1 (c) (ii)) DANGEROUS

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Body mounting fixings insecure (6.2.2 (c) (i))

Nearside Front Lower Headlamp aim too low (4.1.2 (a))

Nearside Rear Anti-roll bar attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Nearside Rear Body component corroded and likely to cause injury (6.2.1 (a) (i))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Inner Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Nearside Rear Inner Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Inner Tyre(s) with different structures are fitted across the same axle (5.2.3 (c))

Offside Front Body component damaged and likely to cause injury (6.2.1 (a) (i))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Tyre(s) with different structures are fitted across the same axle (5.2.3 (c))

Offside Rear Anti-roll bar attachment bracket/mounting corroded and seriously weakened (5.3.3 (b) (i))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Front Body mounting fixings insecure such that stability is seriously impaired (6.2.2 (c) (ii)) DANGEROUS

Offside Front Inner Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

chassis corroded

front and rear suspension corroded

Battery insecure (1.9.1)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp aim beam image kick up to the offside (1.8)

Nearside Outer Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Nearside rear handbrake recording a lower than should be expected maximum brake force

Nearside rear handbrake recording a lower than should be expected maximum brake force

Brake pedal slightly corroded (3.3.A.1a)

Nearside Direction indicator slightly discoloured (1.4.A.2f)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)