2002 Lexus RX300

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

both lower swivel boots perished

rear suspension areas rusty

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Rear Exhaust has a minor leak of exhaust gases silencer (6.1.2 (a))

both lower swivel boots perished

rear suspension areas rusty

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

both rear inner webbs corroded

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear shock absorber corroded and in poor condition

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

rear inner webbs rusty

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

rear webbs corroded

Nearside Outer Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Outer Front suspension ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Offside Rear rear brake binding (3.7.B.1)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside front brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.C.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.C.1b)

both front tyres wearing on inner edge

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Registration plate lamp not working (1.1.5c)