2002 Mazda Premacy

Front Windscreen washer not working (3.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength end of sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength end of sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor x2 (7.1.1 (a) (i))

underside in a rusty condition

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Obligatory mirror seriously damaged, affecting the rear view (3.3 (b) (ii))

Offside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor to sill (7.1.1 (a) (i))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

corossion on rear suspension

Brake pipe corroded, covered in grease or other material Front to Rear covered in underseal (1.1.11 (c))

Front Sub-Frame and underbody covered with underseal

Headlamp lens deteriorated

Rear Child Seat fitted not allowing full inspection of adult belt X 2, 1 on each side ()

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt also split (2.1.3 (g) (ii))

Rear Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Brake pipe corroded, covered in grease or other material Front to Rear covered in underseal (1.1.11 (c))

Front Sub-Frame and underbody covered with underseal

Headlamp lens deteriorated

Rear Child Seat fitted not allowing full inspection of adult belt X 2, 1 on each side ()

Rear Exhaust has a minor leak of exhaust gases centre pipe/back box joint (6.1.2 (a))

Rear Exhaust silencer slightly loose joint with centre pipe corroded (8.1.1 (b) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Nearside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Child Seat fitted not allowing full inspection of adult belt ()

Brake performance not tested osr bent lower arm (1.2.1 (g))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Tyre fouling a part of the vehicle (5.2.3 (f))

Offside Rear Suspension arm insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Rear Child Seat fitted not allowing full inspection of adult belt ()