2003 Ford Focus

Horn not working (7.7 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Seat belt damaged (7.1.2 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Coolant leak ()

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material Front to Rear (1.1.11 (c))

Nearside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside front tyre worn on inner edge

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Brake pipe excessively corroded Nearside and offside front metal brake pipes corroded. (1.1.11 (c))

Brake pipe excessively corroded One main brake pipe corroded. (1.1.11 (c))

Seat belt anchorage prescribed area strength or continuity significantly reduced Both outer sills corroded near seatbelt mounting point, and suspension mounting point. (7.1.1 (a) (i))

Seat belt damaged Driver`s seatbelt badly frayed. (7.1.2 (b) (i))

Offside outer cv boot deteriorating.

Slight coolant leak.

Slight engine oil leak.

Nearside Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Stop lamp not working (1.2.1b)

Offside Stop lamp not working (1.2.1b)

front pads getting low

Power steering pump has slight seepage from a seal (2.3.3b)