2007 Ford Focus

Front Power steering pump has slight seepage (2.1.5 (a))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Front Windscreen washer provides insufficient washer liquid both sides (3.5 (a))

Nearside Front Inner Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Front Outer Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Exhaust has a major leak of exhaust gases box joint (6.1.2 (a))

Front Power steering pump has slight seepage (2.1.5 (a))

Nearside Front Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Rear Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Nearside Track rod end ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Inner Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front wing and door light damage

two front tyre inner edge worn

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Registration plate insecure (0.1 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

auto gear selector need to look at

rear indicators starting to show white light

Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Lower Suspension arm rubber mounting deteriorated resulting in excessive movement rear (2.4.G.2)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Lower Suspension arm rubber mounting deteriorated resulting in excessive movement rear (2.4.G.2)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear indicators starting to show white light

Items removed from driver's view prior to test

Nearside Headlamp not working on dipped beam (1.7.5a)

Items removed from driver's view prior to test

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Headlamp aim too low (1.8)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Headlamp aim too low (1.8)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Child seat fitted not allowing full inspection of adult belt

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)