2008 Mazda 6

Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bushes (5.3.4 (a) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner sills (6.1.1 (c) (i))

Rear subframe corroded

Nearside Front Inner Tyre worn close to legal limit/worn on edge edges (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge edges (5.2.3 (e))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material ends (1.1.11 (c))

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Front tyre worn on inner edge

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

underfloor manufacturer cover fitted unable to fully inspect underside of vehicle

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

underfloor manufacturer cover fitted unable to fully inspect underside of vehicle