2002 Peugeot 206

Fluid leak, but not excessive Slight power steering leak from pressure pipe (8.4.1 (a) (i))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Brake load sensing valve linkage defective and function impaired (1.1.17 (a))

Brake valve leaking load sensing valve (1.1.7 (d) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Headlamp aim too low won't adjust (4.1.2 (a))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Power steering component leaking (2.1.5 (a))

Rear Brake pipe excessively corroded at load sensing valve (1.1.11 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust system insecure (6.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Brake hydraulic reservoir close to minimum mark (1.1.10 (d) (i))

Tyre worn close to legal limit/worn on edge both front (5.2.3 (e))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Emissions not tested (7.3.A.1)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Stop lamp remains on when the brakes are released (1.2.1e)

Offside Stop lamp remains on when the brakes are released (1.2.1e)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

n/s/f tyre worn on inner edge

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

n/s/f tyre worn on inner edge

rear wiper blade split

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

engine management light on

rear wiper blade split

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

nearside front tyre has cut in outer side wall not exposing cord

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)