2006 Citroen Dispatch

Emissions unable to be completed Exhaust major gas leak (8.2.2.2 (e))

Front Exhaust has a major leak of exhaust gases Front pipe onto front silencer (6.1.2 (a))

Fuel tank leaking At filler hose (6.1.3 (b) (i))

Nearside Front Sub-frame corroded and seriously weakened At lower arm mounting point (5.3.3 (b) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush excessively worn Trailing arm bush (5.3.4 (a) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Suspension arm pin or bush excessively worn Trailing arm bush (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Rear Exhaust has a major leak of exhaust gases Silencer (6.1.2 (a))

Front Exhaust silencer likely to become detached (8.1.1 (b) (ii)) DANGEROUS

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust has a minor leak of exhaust gases Center pipe and back box (6.1.2 (a))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Steering linkage ball joint has slight play (2.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Upper Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material To wheel cylinder (1.1.11 (c))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced Outer sill (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Brake pipe corroded, covered in grease or other material To wheel cylinder (1.1.11 (c))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front wheel bearing has slight play (2.5.A.3c)

Supplementary Restraint System warning lamp does not illuminate (5.4.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Parking brake: efficiency below requirements (3.7.B.7)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Nearside Front wheel bearing has slight play (2.5.A.3c)

engine oil leak

Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Suspension arm rubber mounting deteriorated resulting in excessive movement front bush (2.4.G.2)

Nearside Rear Trailing arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber mounting deteriorated resulting in excessive movement rear bush (2.4.G.2)

Offside Rear Trailing arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

engine oil leak

Nearside Outer Front Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

oil leak from engine

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Oil leak

Nail in N/S rear tyre and wearing thin on tread

O/S front tyre wearing thin

Spare tyre flat

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Both front tyres scrubbing off on edges

Nail in N/S rear tyre and wearing thin on tread

Spare tyre flat

Front Brake pad(s) wearing thin (3.5.1g)