2008 Land Rover Range Rover Sport

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Central Prop shaft bearing excessively worn (6.1.7 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Offside Rear Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Lower Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Headlamp aim too low both (4.1.2 (a))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Lower Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front position lamp(s) not working (1.1.A.3b)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Exhaust emits an excessive level of metered smoke (7.4.B.3a)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)