2002 Mazda 6

Central Rear Exhaust has a major leak of exhaust gases box and pipe (7.1.2)

Emissions not tested severe exhaust blowunable to achieve emission reading (7.3.A.1)

Nearside Front Torque/reaction arm has excessive play in a pin/bush rear bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush bushes split and play (2.4.G.2)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded sill holed (2.4.A.3)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill coroded (2.4.A.3)

Offside Front Torque/reaction arm has excessive play in a pin/bush rear bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush bushes split and play (2.4.G.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Central Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. brakes 65 percent imballance (3.7.B.5b)

Central Rear Exhaust noisy box coroded (7.1.4)

Nearside Rear Tyre worn close to the legal limit on 2mm wearbars (4.1.E.1)

Offside Front Tyre worn close to the legal limit scrubbed to wearbars (4.1.E.1)

Offside Front Upper Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Brake pad(s) wearing thin getting low (3.5.1g)

all round damage and drivers mirror back

coolant leak

oil leak

both rear outboard seat belt retracting mechanisms sluggish.

damage in swept area less than 40mm.

exhaust join from centre to back box heavily corroded.

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside front brake binding (3.7.B.1)

Nearside rear brake excessively fluctuating (3.7.B.3)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

both rear outboard seat belt retracting mechanisms sluggish.

damage in swept area less than 40mm.

exhaust join from centre to back box heavily corroded.

n/s/f brake pads wearing thin.

o/s trailing arm bush deteriorated but has no excessive movement.

Engine covers fitted obscuring some components in the engine bay

Nail in nearside rear tyre

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s/f & o/s/f tyres on 2mm wear bars

o/s/f wiper blade torn at edges

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Engine covers fitted obscuring some components in the engine bay

Nail in nearside rear tyre

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Under-trays fitted obscuring some underside components

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

n/s/f & o/s/f tyres on 2mm wear bars

o/s/f wiper blade torn at edges

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear brake binding (3.7.B.1)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

rear brake application uneven (3.7.B.2)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Nearside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

rear brake application uneven (3.7.B.2)

rear pads low

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

airbag light on

Offside Rear Suspension arm which is adjustable, loose in adjustment threads (2.4.G.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

airbag light on

Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

brake disc excessively pitted (3.5.1h)

Brake pad(s) less than 1.5 mm thick (3.5.1g)

brake servo wet new brake pads fitted

Offside Registration plate lamp not working (1.1.5c)

brake servo wet new brake pads fitted