2002 Jaguar Xkr

Exhaust noisy (8.1.1 (a))

Nearside Obligatory mirror slightly damaged (3.3 (b) (i))

Nearside Front Non obligatory mirror damaged ()

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

both rear inner sill starting to rust

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Non obligatory mirror damaged ()

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

both rear inner sill starting to rust

Nearside Front side marker reflector missing

check operation of headlamp washer system

check parking brake condition and operation

door mirror glass starting to deteriorate

fuel cap seal perishing

headlamps have a slight flicker

plastic covers etc prevent full inspection

rear of outer sills + area behind rear of sills/chassis getting rusty

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Headlamp light intensity severely reduced both (4.1.4 (a))

Headlamp cleaning device inoperative (4.1.6 (a) (i))

Nearside Front side marker reflector deteriorated

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside door mirror glass deteriorated

Shock absorbers light misting of oil or has limited damping effect both rear (5.3.2 (b))

both rear exhaust clamps deteriorated, joints slightly loose

fuel cap seal perishing

plastic covers etc prevent full inspection

rear chassis getting rusty

slight ' flicker ' to both dipped beam bulbs

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Upper Suspension arm pin or bush excessively worn inner bushes (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust silencer slightly loose both rear clamps deteriorated (8.1.1 (b) (i))

Nearside Front side marker reflector deteriorated

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside door mirror glass deteriorated

Shock absorbers light misting of oil or has limited damping effect both rear (5.3.2 (b))

fuel cap seal perishing

headlamp washers not working, pre 2009 vehicle

plastic covers etc prevent full inspection

rear chassis getting rusty

slight ' flicker ' to both dipped beam bulbs

m.i.l. is activated

Nearside Rear Subframe mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Stop lamp remains on when the brakes are released with sidelights on (1.2.1e)

m.i.l. is activated

Nearside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Nearside door mirror glass deteriorating

both front to rear brake pipes rusty, replace ASAP

both rear chassis getting rusty

check front brakes for imbalance & judder

check parking brake efficiency

engine MIL on at time of test

exhaust joint clamps in poor condition

fuel cap seal perishing

rear of both outer sills starting to rust

Nearside Front Inner Subframe mounting prescribed area is excessively corroded wheel arch (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Inner Subframe mounting prescribed area is excessively corroded wheel arch (2.4.A.3)

Nearside Front floor panel rusty

Nearside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Nearside door mirror glass deteriorating

Offside Front floor panel rusted & holed, not testable area, repair ASAP

Offside Rear tyre worn to limit, replace ASAP

both front to rear brake pipes rusty, replace ASAP

both rear chassis getting rusty

check front brakes for imbalance & judder

check parking brake efficiency

engine MIL on at time of test

exhaust joint clamps in poor condition

fuel cap seal perishing

rear of both outer sills starting to rust

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Offside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Front registration plate background overprinted or shadowed with text (6.3.1e)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate background overprinted or shadowed with text (6.3.1e)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Offside Rear Drive shaft uj which forms part of the suspension has slight play in a universal joint (2.4.G.4b)

Nearside Front Brake hose slightly chafed (3.6.B.4d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

fuel cap seal slightly perishing

Front registration plate character(s) incorrectly spaced (6.3.4a)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Nearside Front Brake hose slightly chafed (3.6.B.4d)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

fuel cap seal slightly perishing

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front registration plate background overprinted or shadowed with text (6.3.1e)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Rear registration plate background overprinted or shadowed with text (6.3.1e)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

movement in both sides rear hub assemblys

unable to view front and rear inner pads fully

slight blow from front pipe welded joint