2008 Ford Ka

Front Lower Oil leak, but not excessive (8.4.1 (a) (i))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bushes on both sides (5.3.4 (a) (i))

Front Macpherson strut mounting damaged but not seriously weakened both top mounts have slight play (5.3.3 (b) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced general corrosion (6.1.1 (c) (i))

Front Windscreen wiper blade defective both (3.4 (b) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced general corrosion (6.1.1 (c) (i))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Front subframe mount to chassis (6.1.1 (c) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Front subframe mount to chassis (6.1.1 (c) (i))

Rear Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Nearside Front Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced Front subframe mount to chassis (6.1.1 (c) (i))

Both front chassis legs corroding and both rear inner sills corroding.

Catalytic converter heat shield insecure

Fuel filter casing slightly corroded

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords outer sidewall (5.2.3 (d) (i))

Subframe mounting prescribed area is corroded but not considered excessive nearside front and offside front, front mounts close to excessive (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive nearside rear and offside rear inner sills (5.3.6 (a) (i))

corrosion to underside of car and components

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting door sill holed (6.2.2 (d) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

slight corrosion to inner door sill not excessive

unable to fully see brakes recommend inspection

Offside Rear Position lamp not working (4.2.1 (a))

slight corrosion to inner door sill not excessive

unable to fully see brakes recommend inspection

Engine management light illuminated.

engine check light on.

rear tyres aged

Offside Headlamp not working on dipped beam (1.7.5a)

rear tyres aged