2006 Iveco Daily

Brake fluid warning lamp illuminated (1.1.10 (f))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Electronic stability control warning lamp indicates a fault (7.12 (e))

Nearside Front Direction indicator incorrect colour (4.4.3 (a))

Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting n/s sill (6.2.2 (d) (i))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Position lamp with a multiple light source more than 1/2 not functioning no side lights (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Parking (secondary brake) on a single line braking system has no recorded effort at a wheel (1.3.1 (a) (ii)) DANGEROUS

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Inner Brake pipe excessively corroded front (1.1.11 (c))

Nearside Rear Leaf spring anchor pin or bush excessively worn (5.3.4 (a) (i))

Offside Headlamp aim too low and too far to the left. (4.1.2 (a))

Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced rigger (6.1.1 (c) (i))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced o/s and n/s inner sill back (6.1.1 (c) (i))

Nearside Rear Anti-roll bar attachment bracket/mounting missing (5.3.3 (a) (ii)) DANGEROUS

bonnet cable

small stone chip nsf windscreen

Brake fluid significantly below minimum mark warning light on (1.1.10 (d) (ii))

Brake pedal anti-slip provision worn smooth (1.1.2 (c))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Fuel tank insecure both tank straps broken (6.1.3 (a) (i))

Nearside Rear Inner Body component corroded and likely to cause injury wheel arch , floor holed (6.2.1 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Service brake excessively fluctuating (1.2.1 (e))

Offside Rear Inner Body component corroded and likely to cause injury wheel arch , holed (6.2.1 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

clutch pedal rubber missing

small stone chip nsf windscreen

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Position lamp not working (4.2.1 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Bonnet cannot be secured in the closed position (8.4.1)

Offside Headlamp aim too low (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Inner Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Body has a sharp edge caused by damage (6.1.C.1)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Rear fog lamp not working (1.3.2b)

Offside Side repeater incorrect colour (1.4.A.2f)

Nail in nearside rear tyre

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear position lamp(s) not working (1.1.A.3b)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nail in nearside rear tyre

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pedal anti-slip provision incomplete (3.3.A.1b)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside rear brake binding (3.7.B.1)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Upper Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)