2018 Isuzu D-max

Electronic stability control warning lamp indicates a fault (7.12 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Horn not working (7.7 (a))

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Brake performance unable to be tested (1.2.1 (g))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Hydraulic brake cylinder leaking hydraulic fluid Caliper piston. (1.1.16 (b) (i))

Offside Rear Direction indicator adversely affected by the operation of another lamp Trailer board. (4.4.3 (b))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light (4.3.1 (b) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))