2002 Peugeot 206

Nearside Front Shock absorbers has a reduced damping effect (5.3.2 (d))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill feels weak (5.3.6 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill feels weak (5.3.6 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Front inner brake pads struggle to see , wheel removal needed

Nearside Front Suspension arm ball joint has slight play more than slight movement , possible pinch bolt not fully tighten (5.3.4 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill feels weak (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front road wheel bolt shorter than others

Offside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Offside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair lagging in effort, noise (1.2.1 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength facing (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (i))

Front inner brake pads struggle to see , wheel removal needed

Nearside Front Suspension arm ball joint has slight play more than slight movement , possible pinch bolt not fully tighten (5.3.4 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill feels weak (5.3.6 (a) (i))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front road wheel bolt shorter than others

Offside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Offside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair lagging in effort, noise (1.2.1 (c))

fuel tank straps corroded poor condition

Exhaust mounting defective exhaust rubber mountings split and perished (6.1.2 (a))

Fuel tank slightly loose fuel tank straps heavily corroded (6.1.3 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Exhaust mounting defective exhaust rubber mountings split and perished (6.1.2 (a))

Fuel tank slightly loose fuel tank straps heavily corroded (6.1.3 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Side repeater incorrect colour (4.4.3 (a))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Side repeater incorrect colour (4.4.3 (a))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Windscreen wiper blade defective (3.4 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Coil spring corroded both sides (5.3.1 (b) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

both wiper blades poor condition

oil leak

Front Coil spring corroded both sides (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 2mm (5.2.3 (e))

Front coil spring corroded both sides (2.4.C.1b)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Nearside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Front coil spring corroded both sides (2.4.C.1b)

Nearside Front Tyre worn close to the legal limit 3mm (4.1.E.1)

Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside chassis some corrosion

Offside Front Tyre worn close to the legal limit om edges (4.1.E.1)

Offside indicator side repeater faded

Rear both tyres perishing

fuel tank strap corroded

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Side repeater slightly discoloured (1.4.A.2f)

heavy surface rust on fuel tank mounting strap

surface rust on nearside front chassis rail

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Registration plate lamp not working (1.1.C.1d)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Side repeater slightly discoloured (1.4.A.2f)

heavy surface rust on fuel tank mounting strap

surface rust on nearside front chassis rail

offside rear tyre outer sidewall cracking and perishing

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

offside rear tyre outer sidewall cracking and perishing

nearside front tyre wearing on outer edge

Indicator switch faulty (1.4.A.1)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)

n/s & o/s front brake discs worn

Nearside Registration plate lamp not working (1.1.5c)

Nearside Registration plate lamp not working (1.1.5c)

Rear Brake load sensing valve linkage seized (3.6.E.3)