2011 Mercedes-benz C

Nearside Front Suspension arm ball joint excessively worn rear arm (5.3.4 (a) (i))

Front Anti-roll bar linkage ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Parking (secondary brake) grabbing slightly (1.3.1 (c))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened surfaces lipped,would recommend replacing (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin inner pads appear low (1.1.13 (a) (ii))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Brake pad(s) wearing thin approx 3-4 mm (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Outer Tyre has a bulge, caused by separation or partial failure of its structure sidewall (4.1.D.1b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components