2007 Peugeot 308

Brake lever pivot slightly tight (1.1.1 (a))

Front Anti-roll bar ball joint has slight play both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Front Nail in tyre ()

Nearside Front Tyre obviously under inflated (5.2.3 (l))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake lever pivot slightly tight (1.1.1 (a))

Front Anti-roll bar ball joint has slight play both (5.3.4 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Front Nail in tyre ()

Nearside Front Tyre obviously under inflated (5.2.3 (l))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting point (5.3.6 (a) (i))

Nearside Rear wheel has had an adequate repair

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting point (5.3.6 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting point (5.3.6 (a) (i))

Nearside Rear wheel has had an adequate repair

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive axle mounting point (5.3.6 (a) (i))

Offside Side repeater slightly discoloured (4.4.3 (a))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front top suspension mount bearing corroded

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front top suspension mount bearing corroded

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Anti-roll bar has slight play in a ball joint o/s & n/s front (2.4.G.2)

Nearside Rear Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement large axle bush (2.4.G.2)

Offside Front Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

brake disc worn, pitted or scored, but not seriously weakened both front (3.5.1i)

brake disc worn, pitted or scored, but not seriously weakened both rear (3.5.1i)

Offside Front coil spring broken (2.4.C.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)