1986 Austin Mini Mayfair Auto

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive Engine (8.4.1 (a) (i))

Hazard warning switch inoperative (4.4.2 (a) (ii))

Nearside Bonnet primary retaining device ineffective (3.1 (c))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Oil leaking excessively from engine (8.4.1 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Position lamp not working (4.2.1 (a) (ii))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor to sill (6.1.1 (c) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point to sill (6.1.1 (c) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced jacking point to sill (6.1.1 (c) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear Position lamp not working (4.2.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust Loose But Secure

Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced Floor (6.1.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Direction indicator lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Exhaust Loose But Secure

Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced Floor (6.1.1 (c) (i))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Direction indicator lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Exhaust mounting defective (6.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Fuel pipe chafing at carb (6.1.3 (c) (i))

Front Shock absorbers has a reduced damping effect both sides (5.3.2 (d))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced both sides footwell (6.1.1 (c) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Electrical wiring inadequately secured above wheel (4.11 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Horn not working (7.7 (a))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Front Fuel pipe chafing at carb (6.1.3 (c) (i))

Front Shock absorbers has a reduced damping effect both sides (5.3.2 (d))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced both sides footwell (6.1.1 (c) (i))

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Electrical wiring inadequately secured above wheel (4.11 (a) (i))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Front Position lamp not working (4.2.1 (a) (ii))

Horn not working (7.7 (a) (ii))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear Position lamp not working (4.2.1 (a) (ii))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Windscreen washer not working (3.5 (a))

Windscreen wiper not working (3.4 (a))

Nearside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected sub frame (5.3.6 (a) (ii)) DANGEROUS

Offside Electrical wiring likely to touch hot or rotating parts side repeater wiring (4.11 (a) (iii)) DANGEROUS

Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Oil leak ()

Play in steering rack inner joint(s) ()

all 4 tyres perished

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Oil leak ()

Play in steering rack inner joint(s) ()

all 4 tyres perished

Nearside Front Lower Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Upper Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Upper Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

fuel filler cap seal cracked

has a significant engine oil leak

tyres all have cracks in side wall but no visable cords

Nearside Front Headlamp aim too high and too far to the left. (1.8)

Offside Front Headlamp aim too high and too far to the left. (1.8)

Offside Front Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Nearside Front Lower Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Upper Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Upper Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

fuel filler cap seal cracked

has a significant engine oil leak

tyres all have cracks in side wall but no visable cords

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

both front tyres starting to perrish

Offside Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Main beam 'tell-tale' not working (1.7.4c)

Nearside Headlamp aim too high (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)

Offside Front Upper Front suspension has a suspension upper ball joint securing nut loose (2.5.B.1a)

Offside Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)

Offside Steering rack gaiter split (2.2.D.2d)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust system not adequately supported (7.1.1)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust system not adequately supported (7.1.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Fuel system component leaking (7.2.3)

Nearside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Nearside Rear Sub-frame attachment bracket/mounting corroded and its strength is seriously reduced (2.4.G.1)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Front Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Rear Sub-frame attachment bracket/mounting corroded and its strength is seriously reduced (2.4.G.1)

Offside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Engine/gearbox mounting(s) defective

Centre Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.C3)

Offside Front Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.C3)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

corrosion starting on under side of car front and rear