2007 Mercedes-benz Vito

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension spring mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension spring mounting prescribed area damaged but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

Nearside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge worn on inner edge (5.2.3 (e))

Front Exhaust mounting defective (6.1.2 (a))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill jacking point area (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Suspension arm mount (5.3.6 (a) (i))

Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Suspension arm mount (5.3.6 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

all jacking points are corroded

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength jacking point (5.3.6 (a) (i))

all jacking points are corroded

all jacking points are corroded

Offside Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

all jacking points are corroded

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear brake backing plates are corroded

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting inner sill (6.2.2 (d) (i))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Brake pipe leaking on a hydraulic braking system leaking from unions (1.1.11 (b) (ii)) DANGEROUS

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Rear brake backing plates are corroded

High level brake light not working

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Lower Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Upper Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Lower Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Tyre worn close to the legal limit On inner edge (4.1.E.1)

Offside Front Upper Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Headlamp aim too low (1.8)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear coil spring incomplete (2.4.C.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Track rod end ball joint has excessive play (2.2.B.1f) DANGEROUS