1985 Ford Granada

Nearside Front chassis leg corroded

Brake master cylinder close to minimum mark (1.1.10 (d) (i))

Brake pipe corroded, covered in grease or other material both fronts (1.1.11 (c))

Exhaust has a minor leak of exhaust gases front and rear joints (6.1.2 (a))

Offside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Service brake binding but not excessively advise adjustment or repair (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

rear valance / nearside front inner wing holed and corroded / not within load bearing points

Brake pipe slightly corroded both fronts (3.6.B.2c)

Exhaust has a minor leak of exhaust gases centre and rear joint (7.1.2)

Nearside Front Vehicle structure has slight corrosion chassis leg (6.1.A.1)

Offside Rear brake binding slightly

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

rear valance and nearside front inner wing holed and corroded / not within load bearing point

Brake pipe slightly corroded both fronts (3.6.B.2c)

Nearside Front Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front inner wing heavily holed and corroded / not within load 30cm of load bearing point

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Rear Exhaust has a minor leak of exhaust gases box (7.1.2)

Nearside Rear Subframe mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded sill end / inner wheel arch (2.4.A.3)

Offside Front Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Rear Subframe mounting prescribed area is excessively corroded sill end / inner wheel arch (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' crack (8.3.1a)

Brake pipe slightly corroded both fronts (3.6.B.2c)

Nearside Front Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front inner wing heavily holed and corroded / not within 30 cm of load bearing point

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Rear Exhaust has a minor leak of exhaust gases box (7.1.2)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Vehicle structure has slight corrosion (6.1.A.1)

Offside Front Vehicle structure has slight corrosion (6.1.A.1)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

fuel cap seal light perishing

Nearside Headlamp not working on main beam (1.7.5a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

Nearside Rear Vehicle structure has slight corrosion (6.1.A.1)

Offside Front Vehicle structure has slight corrosion (6.1.A.1)

Offside Rear Brake hose has slight corrosion to ferrules (3.6.B.4e)

fuel cap seal light perishing

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Tyre has ply or cords exposed (4.1.D.1b)

Nearside Front Electrical wiring damaged and bare wires exposed (1.9.2c)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Front registration plate faded but not likely to be misread (6.3.1d)

Oil leak

Rear registration plate faded but not likely to be misread (6.3.1d)

nearside front floor corroded and holed not within 30cm of a prescribed area

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Power steering pipe(s) or hose(s) fouling other parts of the vehicle (2.3.2)

Front registration plate faded but not likely to be misread (6.3.1d)

Oil leak

Rear registration plate faded but not likely to be misread (6.3.1d)

nearside front floor corroded and holed not within 30cm of a prescribed area

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Front wheel bearing has excessive play (2.5.A.3c) DANGEROUS

Battery insecure

centre and rear exhaust rubber mounts deteriorating

crack in front number plate and number plate starting to deteriorate

front screenwash jets would benefit from adjustment

minimal play offside front wheel bearing

rear number plate starting to deteriorate

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Fuel cap/sealing device does not fasten securely by positive means (7.2.4b)

Battery insecure

Nearside Outer Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Outer Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

centre and rear exhaust rubber mounts deteriorating

crack in front number plate and number plate starting to deteriorate

front screenwash jets would benefit from adjustment

minimal play offside front wheel bearing

rear number plate starting to deteriorate

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust system not adequately supported (7.1.1)

Nearside Headlamp aim too low (1.8)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too low (1.8)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front wheel bearing has slight play (2.5.A.3c)

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Vehicle structure has slight corrosion (6.1.B.2)

Offside Vehicle structure has slight corrosion (6.1.B.2)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Brake hose slightly deteriorated (3.6.B.4d)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

rear cross member corroded by fuel tank mounting †offside /nearside front chassis member corroded †oil pipes to oil cooler corroded

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

rear cross member corroded by fuel tank mounting