1985 Fiat Ducato

All direction indicators not working When hazards are operated (4.4.1 (a) (ii))

Central Windscreen washer not working (3.5 (a))

Headlamp aim not tested (4.1.2 (b))

Horn not working (7.7 (a) (ii))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Nearside Headlamp insecure (4.1.1 (c))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch in 4 different places (5.3.6 (a) (i))

Offside Headlamp insecure (4.1.1 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Steering component mounting prescribed area is excessively corroded bulkhead near steering rack mount (2.1.2 (e) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Rear brake backing plate has misting of oil around it

Oil leak, but not excessive (8.4.1 (a) (i))

Rear exhaust box blowing

all tyres perished

chassis corroded

Central Front Horn not working (1.6.2a)

Central Front Upper Windscreen washer provides insufficient washer liquid (8.2.3)

Direction indicators not working all four (1.4.A.2c)

Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Upper Headlamp not working on main beam (1.7.5a)

Offside Front Upper Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Offside Rear Upper Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Front coil spring corroded (2.4.C.1b)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

underbody surface corrosion and previous welding work carried out

Hazard warning lamps inoperative (1.4.B.1b)

Hazard warning switch insecure (1.4.B.1d)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear rear brake binding (3.7.B.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear rear brake binding (3.7.B.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear wheel bearing has slight play (2.6.2)

Nearside outer track rod end joint cover split/missing

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside outer track rod end joint cover split/missing

Oil leak

Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Towbar component slightly corroded (6.6.1)

both handbrake cable outer sheaths split

Offside Driver's seat insecure (6.2.A.1)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Hazard warning switch faulty (1.4.B.1d)

Indicator tell tale inoperative (1.4.A.2a)

Nearside Front Passenger's seat insecure (6.2.A.1)

Offside Front Lower Brake hose excessively deteriorated (3.6.B.4d)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Headlamp aim too high (1.8)

Offside Rear wheel bearing rough when rotated (2.6.1)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear wheel bearing has slight play (2.6.2)

Nearside outer track rod end joint cover split/missing

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside outer track rod end joint cover split/missing

Oil leak

Rear Vehicle structure slightly corroded within 30cm of towbar mounting (6.6.6)

Towbar component slightly corroded (6.6.1)

both handbrake cable outer sheaths split

Driver's door does not latch securely closed (6.2.B.1a)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Hazard warning switch faulty (1.4.B.1d)

Nearside Front Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Vehicle structure is damaged, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has an inadequate repair, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Body has slight corrosion (6.1.B.2)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Inner Rear Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Suspension joint offside lower dust cover split/missing

drivers seat runners worn

nearside wiper arm mounting corroding

Horn not working (1.6.2a)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension joint offside lower dust cover split/missing

drivers seat runners worn

nearside wiper arm mounting corroding

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Offside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Suspension joint offside lower dust cover split/missing

drivers seat runners worn

Exhaust system not adequately supported (7.1.1)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Suspension joint offside lower dust cover split/missing

drivers seat runners worn

Battery insecure

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Suspension joint offside lower dust cover split/missing

offside front seat runners worn

parking brake effort just on required limit

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly pitted (3.5.1h)

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Offside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Registration plate lamp not working (1.1.5c)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front brake disc slightly pitted (3.5.1h)

Offside Front brake disc slightly pitted (3.5.1h)