1986 Toyota MR2

Coolant leak ()

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Inner Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Brake linkage worn but not seriously weakened (1.1.15 (b))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Brake repair covered in underseal (1.1.21 (e) (i))

Offside Rear Inner Sub-frame is fractured but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Inner Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Coolant leak ()

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

under vehicle covered/corroded unable to check properly-

all under vehicle corroded/covered by substance unable to check properly-x2 front coil springs corroded-rear brake discs corroded

Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Registration plate lamp does not illuminate simultaneously with the position lamps inop (4.7.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Stop lamp(s) not working nearside rear (4.3.1 (a) (ii))

Suspension component attachment bracket/mounting corroded and seriously weakened n/s/f/ suspension arm balljoint (5.3.3 (b) (i))

Suspension component attachment bracket/mounting damaged and seriously weakened n/s/r/rear suspension arm (5.3.3 (b) (i))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced n/s/f/ inner sill holed (6.1.1 (c) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

all under vehicle corroded/covered by substance unable to check properly-x2 front coil springs corroded-rear brake discs corroded

rear service and parking brake passed on limit-rear brakes slightly binding-x2 front flexi hoses deteriorated-under vehicle covered by substance, unable to check properly

welding covered by substance, unable to check properly

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch/inner sill holed, visible from under vehicle (2.4.A.3)

Nearside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front Suspension component mounting prescribed area is excessively corroded floor area holed (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded outer sill holed (2.4.A.3)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

rear service and parking brake passed on limit-rear brakes slightly binding-x2 front flexi hoses deteriorated-under vehicle covered by substance, unable to check properly