1986 Toyota MR2

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front coolant pipe jubilee clip broken

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Inner Steering rack has slight free play detected at steering wheel rack joint (2.3 (a) (i))

Nearside Front Upper top strut mounting slight play

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear brake back plates heavily corroded

Brake Disc Back Plates Corroded

Clutch Slave Cylinder Hydraulic Pipe Insecure

Coolant Pipes Corroded

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Play in steering rack inner joint(s)

Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake Disc Back Plates Corroded

Clutch Slave Cylinder Hydraulic Pipe Insecure

Coolant Pipes Corroded

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Play in steering rack inner joint(s)

Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Brake back plates deteriorated

Coolent pipes rusty

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

both rear tyres smooth on inner edge(s)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside rear brake binding (3.7.B.1)

both rear tyres smooth on inner edge(s)

Coolant leak

Nearside front anti roll bar link rod worn slightly

Offside rear tyre worn on inner edge

Oil leak

Rear tie bar outer joints on incorrect angle

Nearside Front Lower Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Coolant leak

Nearside front anti roll bar link rod worn slightly

Offside rear tyre worn on inner edge

Oil leak

Rear tie bar outer joints on incorrect angle

Offside Front wheel bearing has slight play (2.5.A.3c)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Front wheel bearing has slight play (2.5.A.3c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)