2002 Mazda 323

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Fuel tank leaking (6.1.3 (b) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis on floor (6.1.1 (c) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced floor (6.1.1 (c) (i))

Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Brake fluid warning lamp illuminated (1.1.10 (f))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Emissions not tested major exhaust leak (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust system insecure (6.1.2 (a))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases badly rusted (6.1.2 (a))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension rod pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Outer Suspension rod pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension rod pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Rear Service brake excessively fluctuating (1.2.1 (e))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wing (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Power steering malfunctioning (2.1.5 (a))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases badly rusted (6.1.2 (a))

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension rod pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Outer Suspension rod pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension rod pin or bush worn but not resulting in excessive movement front (5.3.4 (a) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

EXCESSIVE corrosion on vehicle underside

Nearside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Rear Inner Suspension component mounting prescribed area is excessively corroded wheel arch/sill (2.4.A.3)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Subframe mounting prescribed area is excessively corroded chassis (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded under bonnett (2.4.A.3)

Offside Rear Inner Suspension component mounting prescribed area is excessively corroded wheel arch/sill (2.4.A.3)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

EXCESSIVE corrosion on vehicle underside

Oil leak ()

Tyre worn close to the legal limit inner edge (4.1.E.1)

Vehicle structure has slight corrosion (6.1.B.2)

Vehicle structure has slight corrosion (6.1.B.2)

exhaust system corroded

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Vehicle structure has slight corrosion (6.1.B.2)

exhaust system corroded

Vehicle structure has slight corrosion (6.1.B.2)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Vehicle structure has slight corrosion (6.1.B.2)

Both wiper blades split and are slightly smearing

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Direction indicators incorrect colour (1.4.A.2f)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

front brake discs worn (inner faces) not considered excessive

mark in windscreen, not considered excessive or to be seriously affecting drivers view

offside rear tyre uneven wear detected (inside edge)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

front brake discs worn (inner faces) not considered excessive

mark in windscreen, not considered excessive or to be seriously affecting drivers view

offside rear tyre uneven wear detected (inside edge)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

N/s wiper split on bottom edge

Nearside Stop lamp not working (1.2.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

N/s wiper split on bottom edge

Offside Side repeater not working (1.4.A.2c)

Rear registration plate insecure (6.3.1b)