2002 Peugeot 206

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive Servo mount (1.1.21 (e) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension component ball joint excessively worn (5.3.4 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive Servo mount (1.1.21 (e) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Road wheel slightly distorted (5.2.2 (c) (i))

Offside Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Sill (6.1.B.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Braking system leaking Load sensing valve (3.6.A.1)

Offside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Emissions not tested (7.3.A.1)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Oil leak

Nearside Front Anti-roll bar ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

n/s rear tyre cracking

Brake load sensing valve linkage seized (3.6.E.3)

Fuel system component insecure (7.2.1)

Nearside Front Bonded suspension unit deteriorated and cannot function as intended (2.4.F.3)

Oil leak

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Oil leak

Nail in nearside rear tyre

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)