2003 Mazda MX-5

Driver's airbag missing (7.1.5 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Fluid leak harmful to the environment or a risk to other road users coolant (8.4.1 (a) (i))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Horn not working (7.7 (a) (ii))

Nearside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength spring area (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected chassis (5.3.6 (a) (ii)) DANGEROUS

Exhaust mounting defective (6.1.2 (a))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Electrical wiring inadequately secured abs (4.11 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Horn not working (7.7 (a) (ii))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Offside Rear Road wheel fixing missing (5.2.1 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Position lamp incorrect colour (4.2.3 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front tyre worn on outer edge

Rear Brake pad(s) wearing thin (3.5.1g)

Front both on outside edges

underside of vehicle heavily undersealed

Nearside front brake binding (3.7.B.1)

Offside front brake binding (3.7.B.1)

front brake application uneven nearside higher (3.7.B.2)

Front both on outside edges

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

underside of vehicle heavily undersealed

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Suspension component mounting prescribed area is excessively corroded chassis (2.4.A.3)

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Anti-roll bar attachment bracket/mounting insecure (2.4.G.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension component mounting prescribed area is excessively corroded chassis (2.4.A.3)

Offside Front front brake binding (3.7.B.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Battery not holding charge

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit both bald on outside edges (4.1.E.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside parking brake performance low

Offside Headlamp aim too low adjusted (1.8)

Oil leaking

Rear Brake pad(s) wearing thin (3.5.1g)

Tyre pressures low

Underside chassis, floor pans, inner and outer sills slightly corroded

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Under-trays fitted obscuring some underside components

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Under-trays fitted obscuring some underside components

Centre Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Brake pad(s) insecure (3.5.1g) DANGEROUS

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Lower Body has slight corrosion (6.1.B.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Lower Body has slight corrosion (6.1.B.2)

Nearside Rear Lower Body has slight corrosion (6.1.B.2)

Offside Front Lower Body has slight corrosion (6.1.B.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too high (1.8)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Headlamp aim too high (1.8)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)