2003 Subaru Forester

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

engine running rough

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive engine (8.4.1 (a) (i))

engine running rough

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Headlamp lenses poor condition

Rear axle cross beam bushes worn

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Not able to fully inspect all metal brake pipes

Plastic sill covers fitted not allowing inspection of outer body sills

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Electrical wiring damaged and bare wires exposed Under bonnet (1.9.2c)

Not able to fully inspect all metal brake pipes

Plastic sill covers fitted not allowing inspection of outer body sills

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

both front tyres wearing on edges

Tow ball/hitch not fitted at time of test

Under-trays fitted obscuring some underside components

unable to see main brake pipes [running through chassis ]

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front brake pads half worn

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear registration plate deteriorated (6.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)