2007 Ford Focus

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Emissions not tested due to modified/made up exhaust (8.2.1.2 (d))

Exhaust system insecure exhaust system fouling rear subframe (6.1.2 (a))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill, inadequate repair, not fully seem welded (6.1.1 (c) (i))

Offside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate insecure (0.1 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Rear Exhaust shield missing where fitted as original equipment creating a risk of fire hanging off (6.1.3 (e)) DANGEROUS

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated replaced using incorrect cv boot (6.1.7 (g) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Position lamp incorrect colour nearside and offside front position lamps show pink/purple (4.2.3 (a) (i))

Emissions not tested due to ehaust blowing (8.2.1.2 (d))

Exhaust has a major leak of exhaust gases exhaust blowing from various joints /emmissions affected (6.1.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Rear Registration plate missing (0.1 (a))

Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced both rear sills corroded (6.1.1 (c) (i))

Exhaust shield missing where fitted as original equipment creating a risk of fire heat sheild insecure likely to fall off (6.1.3 (e)) DANGEROUS

advise park brake travel/performance

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Nearside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

rear lateral arm bushes deteriorated no movement

Nearside Front Direction indicator slightly discoloured (1.4.A.2f)

Nearside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

rear lateral arm bushes deteriorated no movement

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Stop lamp not working (1.2.1b)

Registration plate lamp not working (1.1.C.1d)

front brake application uneven (3.7.B.2)