2008 Ford Ka

Nearside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush excessively worn inner / rear (5.3.4 (a) (i))

Offside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement rear (5.3.4 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

weld repair covered in under seal

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength both chassis (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive both floor and chassis (5.3.6 (a) (i))

Nearside Front Tyre slightly damaged/valve stem damaged tyre valve perrished (5.2.3 (d) (i))

Offside Front Tyre worn close to legal limit/worn on edge 165/60/14 (5.2.3 (e))

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement rear bush. (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Nail in tyre x2 ()

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

crack on windscreen

exhaust corroded

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Front Brakes imbalanced across an axle (3.7.B.5b)

front brake application uneven (3.7.B.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

18% imbalance on front brakes.

Some pitting on offside front brake disc.

Horn not working (1.6.2a)

18% imbalance on front brakes.

Some pitting on offside front brake disc.