2005 Mercedes-benz C

Electronic stability control warning lamp indicates a fault (7.12 (e))

Front Headlamp has a product on the lens so that the light output is severely reduced both sides (4.1.4 (b))

Nearside Front Lower Suspension arm ball joint excessively worn both arms (5.3.4 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Side repeater likely to become detached lens broken (4.4.1 (c) (ii))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded Both Sides. (5.3.1 (b) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Anti-roll bar pin or bush excessively worn bracket bush (5.3.4 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Anti-roll bar pin or bush excessively worn bracket bush (5.3.4 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Central Rear Exhaust has a minor leak of exhaust gases deteriorated (6.1.2 (a))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Side repeater lens defective which has no effect on emitted light (4.4.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

long travel in parking brake

low parking brake efficiency

Both rear wrap around anti roll bar bushes deteriorating

O/s front brake dust cover missing

Oil leak, but not excessive (8.4.1 (a) (i))

One rear exhaust mounting missing

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Both rear wrap around anti roll bar bushes deteriorating

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

O/s front brake dust cover missing

Oil leak, but not excessive (8.4.1 (a) (i))

One rear exhaust mounting missing

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Gear box oil leak

N/s front tyre worn on outside edge

O/s front brake dust cover rusty

One rear exhaust metal mounting missing

Rear Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Inside surface of front brake disc's are going rusty

Slight auto gearbox oil leak

Front Outer Suspension arm has excessive play in a ball joint both TCA's (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Inside surface of front brake disc's are going rusty

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Slight auto gearbox oil leak

Inner edges of front brake disc's are going rusty

Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front brake pads are coming near to sensor wire.

Inside surface of front brake disc's are going rusty.

Rear Tyre worn close to the legal limit (4.1.E.1)

Inside surface of front brake disc's are going rusty.

Rear Tyre worn close to the legal limit (4.1.E.1)

Surface rust on rear anti roll bar.