2005 Ford Focus

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected Outer sill (5.3.6 (a) (ii)) DANGEROUS

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Brake cable has restricted free movement (1.1.15 (e))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Outer sill (5.3.6 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front brake disc and pads need attention

Oil leak, but not excessive (8.4.1 (a) (i))

Child Seat fitted not allowing full inspection of adult belt ()

Coolant leak ()

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Outer Brake pipe excessively corroded (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Child Seat fitted not allowing full inspection of adult belt ()

Coolant leak ()

Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced Inner sills (6.1.1 (c) (i))

Water leel

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear inner sills very corroded

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front front brake application uneven (3.7.B.2)

Nearside Rear Brake pipe excessively corroded By fuel tank (3.6.B.2c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)