2008 Ford Ka

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake prescribed area is excessively corroded chassis (1.1.21 (e) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Coolant level low

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge bald (5.2.3 (e))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced floor (6.1.1 (c) (i))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Vehicle structure is corroded but structural rigidity is not significantly reduced floor (6.1.1 (c) (i))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Brake prescribed area is excessively corroded (1.1.21 (e) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Nearside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Nearside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake prescribed area is corroded but not considered excessive (1.1.21 (e) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

general corrosion on underside of vehicle

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

general corrosion on underside of vehicle

o/s/f lower arm inner bushes slightly displaced

small cut/ seep n/s/f outer CV gaiter

various underside surface corrosion

Corrosion around fuel filler neck.

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust system insecure (6.1.2 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch inoperative (4.5.3 (a) (ii))

Corrosion around fuel filler neck.

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension arm has slight play in a pin/bush axle (2.4.G.2)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension arm has slight play in a pin/bush axle (2.4.G.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension arm has slight play in a pin/bush axle (2.4.G.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension arm has slight play in a pin/bush axle (2.4.G.2)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Lower Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Child seat fitted not allowing full inspection of adult belt

noise from offside rear brake drum

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Stop lamp not working (1.2.1b)

Child seat fitted not allowing full inspection of adult belt

noise from offside rear brake drum

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)