2009 Fiat Panda

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

anti slip coating missing on clutch pedal

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

anti slip coating missing on clutch pedal

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear axel beam corroded but not weakened

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

rear axel beam corroded but not weakened

rear beam corroded

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Suspension spring mounting prescribed area is corroded but not considered excessive beam axle (2.4.A.3)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Exhaust rear silencer detiorated.

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)