2010 Honda Cbf 125 M-a

Drive chain slightly loose (6.1.7 (c) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Wheel alignment slightly misaligned Forks slightly twisted in yokes (2.4 (a))

Drive chain slightly loose Advise loose / NEAR FAIL (6.1.7 (c) (i))

Front Brake pad(s) close to minimum limit Advise front brake pads getting low (1.1.13 (a))

Front Mudguard insecure Advise front mudguard been temp taped / repair ()

Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Clutch lever bent (6.2.7 (b))

Drive chain slightly tight (6.1.7 (k) (i))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Clutch lever bent (6.2.7 (b))

Drive chain slightly tight (6.1.7 (k) (i))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Drive chain slightly loose (6.1.7 (c) (i))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Handlebar deformed but serviceable (2.2.1 (c) (i))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Stop lamp does not illuminate by the operation of both brake controls Rear switch disconnected (4.3.2 (a) (iii))

Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Front Handlebar deformed but serviceable (2.2.1 (c) (i))

Nearside Front Footrest slightly loose (6.2.12 (a))

Offside Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Front Handlebar deformed but serviceable (2.2.1 (c) (i))

Nearside Front Footrest slightly loose (6.2.12 (a))

Offside Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

o/side front indicator lens missing

Offside Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

o/side front indicator lens missing