2010 Peugeot 107

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (o/s and n/s) (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (o/s and n/s) (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake disc worn, pitted or scored, but not seriously weakened both sides (o/s and n/s) (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin both sides (o/s and n/s) (1.1.13 (a) (ii))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

underneath corrosion various places

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Anti-roll bar corroded but not seriously weakened BOTH (5.3.3 (b) (i))

Front Hazard warning switch faulty (4.4.2 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement BOTH FRONT LOWER ARM REAR BUSH (5.3.4 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust system not adequately supported (7.1.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)