2002 Peugeot 206

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Side repeater not working (4.4.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Rear Exhaust system insecure (6.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Brake performance unable to be tested (1.2.1 (g))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Vehicle structure is fractured and structural rigidity is significantly reduced (6.1.1 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Side repeater not working (4.4.1 (a) (ii))

Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Brake pipe excessively corroded (1.1.11 (c))

Rear Brake pipe excessively corroded (1.1.11 (c))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Outer Drive shaft joint excessively worn (6.1.7 (c) (i))

Offside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Nearside Front Outer Drive shaft joint worn, but not excessively (6.1.7 (c) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust on a vehicle fitted with a diesel particulate filter emits visible smoke of any colour (8.2.2.2 (d))

Fuel tank insecure (6.1.3 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Brake load sensing valve seized and ABS not fitted or inoperative (1.1.17 (c) (ii)) DANGEROUS

Indicator switch faulty (4.4.2 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Rear Brake damaged to the extent that braking performance is affected (1.1.21 (a) (ii)) DANGEROUS

Indicator switch faulty (4.4.2 (a) (i))

Brake load sensing valve seized (3.6.E.3)

Nearside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Stop lamp not working (1.2.1b)

Offside rear brake binding (3.7.B.1)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Bonded suspension unit deteriorated and cannot function as intended (2.4.F.3)

Offside Front Lower Anti-roll bar linkage ball joint dust cover missing (2.4.G.2)

Offside Front Upper Anti-roll bar linkage ball joint dust cover missing (2.4.G.2)

Offside Front Lower Anti-roll bar has slight play in a ball joint (2.4.G.2)

Fuel tank insecure (7.2.1) DANGEROUS

Offside Front Lower Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Headlamp aim too high (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust system not adequately supported (7.1.1)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Rear Exhaust system not adequately supported (7.1.1)

Rear registration plate deteriorated (6.3.1d)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Front brake discs worn

both front tyres wearing on edges.

o/s front tyre low on tread pattern and worn on inner edge