2002 Peugeot 206

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Front Drive shaft flexible coupling excessively deteriorated (6.1.7 (d) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake excessively binding x2 (1.2.1 (f))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front coil spring corroded n/s and o/s (2.4.C.1b)

advise corrosion to o/s outer sill area

advise fuel tank support strap corroded

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Offside Rear Stop lamp not working (1.2.1b)

Front coil spring corroded n/s and o/s (2.4.C.1b)

advise corrosion to o/s outer sill area

advise fuel tank support strap corroded

Rear Tyre worn close to the legal limit n/s and o/s (4.1.E.1)

advise fuel tank strap weak

Front Anti-roll bar linkage has excessive play in a ball joint n/s and o/s (2.4.G.2)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear Tyre worn close to the legal limit n/s and o/s (4.1.E.1)

advise fuel tank strap weak

Front coil spring corroded (2.4.C.1b)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Steering rack gaiter split (2.2.D.2d)

Front coil spring corroded (2.4.C.1b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

o/s front suspension strut top mounting noisy

Nearside Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Suspension arm synthetic bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front constant velocity joint is insecure (2.5.C.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Steering rack gaiter split (2.2.D.2d)

rear exhaust starting to rust

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)