2003 Mazda MX-5

Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt offside & nearside (5.3.4 (b) (ii))

Nearside Outer Seat belt anchorage prescribed area is inadequately repaired (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength more than one place (5.3.6 (a) (i))

Outer Seat belt anchorage prescribed area strength or continuity significantly reduced offside & nearside (7.1.1 (a) (i))

Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced offside & nearside (7.1.1 (a) (i))

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Exhaust has a minor leak of exhaust gases deteriorated (6.1.2 (a))

Front Service brake fluctuating, but not excessively offside & nearside more than slight (1.2.1 (e))

Front Suspension component mounting prescribed area is corroded but not considered excessive offside & nearside (5.3.6 (a) (i))

Front Upper Suspension arm ball joint dust cover severely deteriorated offside & nearside (5.3.4 (b) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Headlamp lens slightly defective offside & nearside (4.1.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Coil spring corroded offside & nearside (5.3.1 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive offside & nearside (5.3.6 (a) (i))

Rear Upper Suspension arm corroded but not seriously weakened offside & nearside (5.3.3 (b) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive offside & nearside inner & outer (7.1.1 (a) (i))

Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt offside & nearside (2.1.3 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

exhaust blow

n/s sill rusting

rear pads low

rust to sills and chassis and suspension componants

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.D.4)

exhaust blow

n/s sill rusting

rear pads low

rust to sills and chassis and suspension componants

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake lever has little reserve travel n/s/r parking brake reading low (3.1.6b)

n/s/r & o/s/r outer sills corroded

rust to sills

slight blow rear exhaust

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.D.4)

rust to sills

slight blow rear exhaust

light misting on o/s rear brake caliper

rust to sills

slight bind o/s frt

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

n/s rear tyre low tread

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Windscreen wiper blade insecure (8.2.2)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper blade insecure (8.2.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

handbrake travel

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Headlamp aim too high (1.8)

Nearside Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen wiper blade deteriorated (8.2.2)

Offside Front Windscreen wiper blade deteriorated (8.2.2)