2003 Peugeot 206

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake valve corroded and excessively weakened (3.6.A.2b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2) DANGEROUS

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn on inner outer edge 3MM

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Tyre worn on inner edge

Oil leak Engine ()

Brake load sensing valve stiff (3.6.E.3)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Brake load sensing valve stiff (3.6.E.3)

Nearside Front Anti-roll bar has slight play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

near side front tyre becoming close to limet

slight blow on front exhaust down pipe

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Exhaust system not adequately supported (7.1.1)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Headlamp not working on dipped beam (1.7.5a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Brake load sensing valve linkage seized (3.6.E.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)