2008 Ford Ka

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced side sill (6.1.1 (c) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced side sill (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced side sill (6.1.1 (c) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sill (6.2.2 (d) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting Chassis above back box bracket (6.2.2 (d) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all around chassis (6.1.1 (c) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Hazard warning switch inoperative does not light up when working (4.4.2 (a) (ii))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Stop lamp not working (1.2.1b)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

corrosion starting in both front chassis legs