2002 Fiat Doblo

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear inner sill has corrosion starting

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced inner crossmember (6.1.1 (c) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Nearside Rear handbrake cable in poor condition

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Nearside Rear handbrake cable in poor condition

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Body has slight corrosion chassis rail (6.1.B.2)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Service brake: efficiency below requirements (3.7.B.7)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Body has slight corrosion chassis rail (6.1.B.2)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

rear brake application uneven o/side rear low (3.7.B.2)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside rear brake recording little or no effort (3.7.B.5a)

centre stop not working

osf track rod end has border line play in a ball joint

rear and front no.plates deteriated

rear indicators slightly discoloured

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Headlamp aim too high and too far to the left. (1.8)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Headlamp aim too high (1.8)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Front brake disc excessively scored (3.5.1h)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front brake disc excessively scored (3.5.1h)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Centre Rear Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Tyre worn close to the legal limit (4.1.E.1)

condition of both rear tyre valves