2003 Ford Ka

Emissions not tested (7.3.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Vehicle structure has excessive corrosion which adversely affects braking or steering (6.1.A.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

engine management light on

front inner wings corroded slightly

Centre Exhaust system not adequately supported (7.1.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Upper Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

front inner wings corroded slightly

Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

spare wheel missing

Nearside Front Lower Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Road wheel bead rim badly distorted (4.2.A.1a)

Offside Front coil spring fractured (2.4.C.1a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Nail in nearside rear tyre

Nail in offside rear tyre

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

spare wheel missing

Play in both front anti roll bar bushes

Offside Headlamp aim too high (1.8)

Braking system leaking (3.6.A.1)

Nearside Headlamp aim too low (1.8)

rear brake application uneven (3.7.B.2)

Brake fluid level low

Offside rear steel brakepipe rusty

Offside rear tyre walls cracking

Play in both front anti roll bar bushes

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

both outer sills corroded

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

both outer sills corroded

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Brake hose excessively deteriorated (3.6.B.4d)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake hose excessively deteriorated (3.6.B.4d)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)