2008 Mazda 3

Nearside Front Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Position lamp showing white light to the rear (4.2.3 (a) (ii))

Nearside Rear Stop lamp(s) emits other than a steady red light (4.3.3 (a) (ii))

Nearside Front Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Offside Front Headlamp has a product on the light source but not seriously reducing light output (4.1.4 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Position lamp has a product on the lens or light source which shows white light to the rear both sides (4.2.3 (b) (ii))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Front Registration plate inscription illegible (0.1 (b))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake lever defective but can be satisfactorily operated (1.1.6 (d))

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Oil leak

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Offside Registration plate lamp not illuminating the registration plate (1.1.C.1e)