MOT Status
ExpiredMileage
66,495 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))
Rear Exhaust system insecure corrosion (6.1.2 (a))
Offside Front Floor in such a condition it is likely to cause load insecurity or instability seat mounting holed/corroded to excess (6.2.4 (a) (ii)) DANGEROUS
Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected subframe mounting corroded to excess (5.3.6 (a) (ii)) DANGEROUS
Nearside Front Tyre worn close to legal limit/worn on edge 3mm. worn edges/cracking (5.2.3 (e))
Nearside Rear Tyre worn close to legal limit/worn on edge 3mm,/tread cracking worn edges (5.2.3 (e))
Offside Rear Tyre worn close to legal limit/worn on edge 3mm. tread cracking (5.2.3 (e))
Offside Rear inner wing and boot floor corroded/holed
Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
advise both front tyres wearing on inner edges
Front Windscreen wiper does not clear the windscreen effectively blades split (8.2.2)
Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings centre floor panel corroed (6.1.B.2)
advise both front tyres wearing on inner edges
Body has slight corrosion through out under side of vehicle (6.1.B.2)
Nearside Front Bonded suspension unit deteriorated but can function as intended wishbone (2.4.F.3)
Radius arm has slight play in a pin/bush n/s & o/s rear axle beam (2.4.G.2)
Body has slight corrosion through out under side of vehicle (6.1.B.2)
Nearside Front Bonded suspension unit deteriorated but can function as intended wishbone (2.4.F.3)
Radius arm has slight play in a pin/bush n/s & o/s rear axle beam (2.4.G.2)
Registration plate lamp not working (1.1.C.1d)
underside of vehicle has slight surface corrosion
Rear Registration plate lamp not working both (1.1.C.1d)
underside of vehicle has slight surface corrosion
Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Seat belt mounting to floor (6.1.B.2)
Rear Registration plate lamp not working (1.1.C.1d)
Front Inner Both sides Cross member mountings have bad corrosion
Nearside Inner Inner sill to floor has corrosion also rear foot wells
Offside Inner Inner sill to floor has corrosion also the rear foot well
Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)
Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)
offside front tyre bald on raised edge
Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)
How Reliable is the Ford Ka?
Based on 8,818,307 MOT tests across 675,715 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
CE58 YUW is a 2008 Ford Ka in Red with a 1,299cc petrol engine. This vehicle has been through 16 MOT tests with a personal pass rate of 56.3%.
Across all 2008 Ford Ka models, the average MOT pass rate is 71.0% with a typical mileage of 41,756 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Ford Ka fails its MOT is suspension component mounting prescribed area is excessively corroded, accounting for 404,005 recorded failures. If you're considering buying CE58 YUW, it's worth having these areas checked by a mechanic before committing.
The Ford Ka typically stays on UK roads for around 29 years. At 18 years old, this Ford Ka is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of CE58 YUW?
You can check the full history of CE58 YUW by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was CE58 YUW registered?
CE58 YUW is a 2008 Ford Ka, first registered on 30 September 2008.
Is CE58 YUW safe to buy?
The MOT history for CE58 YUW shows 16 tests with a 56.3% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does CE58 YUW have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on CE58 YUW. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.